Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 383

Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check setpoint value and parameter _TSA
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check setpoint value and parameter TSA
61304 [Channel %1: ] Block %2: Allowance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
61305 [Channel %1: ] Block %2: Dimension too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
61306 [Channel %1: ] Block %2: Permissible measuring difference exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check setpoint value and parameter DIF
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check setpoint value and parameter DIF
61307 [Channel %1: ] Block %2: Incorrect measuring variant
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- The value of parameter _MVAR is impermissible.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- The value of parameter S_MVAR is impermissible.
61308 [Channel %1: ] Block %2: Check measuring path
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: A traversing path for measuring is generated with a size that can be specified. It describes the maximum distance
before and after the expected switching position (workpiece edge) and must have a value greater than 0.
In the AUTOMATIC operating mode:
For 840D sl - to SW 2.6 SP1 and for 828D - to SW 4.3 :
- Check parameter_FA
For 840D sl - from SW 2.7 and for 828D - from SW 4.4 :
- Check parameter DFA
In the JOG mode:
For 840D sl - from SW 2.7 and for 828D - from SW 4.4 :
- Check parameters MD51786: $MNS_J_MEA_T_PROBE_MEASURE_DIST, MD51752:
$MNS_J_MEA_M_DIST_TOOL_LENGTH and MD51753: $MNS_J_MEA_M_DIST_TOOL_RADIUS
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
383