Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 380
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61280
[Channel %1: ] Block %2: %4- Mirroring missing in work offset for counterspindle
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The work offset for counterspindle machining does not have Z mirroring.
Remedy:
Select Z mirroring for the work offset used.
61281
[Channel %1: ] Block %2: starting point of machining outside retraction planes
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The starting point of machining is outside the retraction planes.
Remedy:
Adjust the retraction planes.
61282
[Channel %1: ] Block %2: end point of machining outside retraction planes
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The end point of machining is outside the retraction planes.
Remedy:
Adjust the retraction planes.
61283
[Channel %1: ] Block %2: direct approach not possible, as tool change required
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
After block search a position is to be reached by direct approach, but a tool change is required before.
Remedy:
First execute a manual tool change, then restart the block search.
61284
[Channel %1: ] Block %2: starting point cannot be approached without collision. Pre-
position tool manually
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The starting point cannot be approached without collisions.
Remedy:
Preposition the tool manually.
61285
[Channel %1: ] Block %2: parking position is below return plane XRA.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The parking position is below retraction plane XRA.
Remedy:
Move the parking position above retraction plane XRA.
61286
[Channel %1: ] Block %2: machining not possible, check tool angle.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Machining not possible with the specified tool.
Remedy:
Use a suitable tool.
61287
%[[Channel %1: ] Block %2: %]No master spindle active.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No master spindle active.
Remedy:
Activate the master spindle (machine data 20090).
380
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
