Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 364

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
Remedy: Reduce plane infeed or slot width, or use milling cutter with larger diameter
61161 [Channel %1: ] Block %2: Centering diameter or tool parameter (diameter, tip angle) are
incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: - Diameter of centering with tip angle of active tool not possible
- Entered workpiece diameter, tool diameter or tip angle of tool incorrect
- Diameter of tool only has to be entered if centering is to be on workpiece diameter.
61162 [Channel %1: ] Block %2: Tool parameter diameter or tip angle incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: - The tool parameter diameter or tip angle must be greater than zero
- Tip angle must be less than 180°
61163 [Channel %1: ] Block %2: Infeed width in the plane too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: --
61164 [Channel %1: ] Block %2: Transformation has incorrect type %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The transformation has the incorrect type. Correct the transformation set up.
61165 [Channel %1: ] Block %2: Transformation set up incorrectly: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The transformation has been set up incorrectly. Correct the transformation set up.
61166 [Channel %1: ] Block %2: Check machine data: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The machine data must be checked. Adapt the setting of the machine data.
61167 [Channel %1: ] Block %2: Transformation not set up: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The specified transformation is not set up. Set up the transformation.
364
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual