Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 187

14159 [Channel %1: ] Block %2 more than two angles programmed with ROTS or AROTS
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Frame rotations are described using space angles with the language commands ROTS or AROTS. A maximum of two
angles can be programmed.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Modify program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14160 [Channel %1: ] Block %2 tool length selection without geometry axis specification
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If variant C (tool length acts on the programmed axis) is activated by machine data MD20380
$MC_TOOL_CORR_MODE_G43G44 for tool length compensation with H word and G43/G44 in ISO_2 mode, at least
one geometry axis must be specified.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change MD20380 $MC_TOOL_CORR_MODE_G43G44 or the part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14165 [Channel %1: ] Block %2 selected ISO H/D number %3 does not match tool %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = ISO H/D number
%4 = Tool number
Definitions: When an H or D number is programmed in ISO_2 or ISO_3 mode, it must be available in the active tool. The active
tool may also be the last tool loaded on the master spindle or master toolholder. This alarm is output if there is no H
or D number on this tool.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Set ISO H/D number correctly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14166 [Channel %1: ] Block %2 error %3 when programming a tool length offset with TOFF /
TOFFL
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: An error occurred while programming a tool length offset with TOFF or TOFFL. More information about the type of
error is given by the error code number:
Error code
1At least one tool length offset component has been programmed twice in one block (with TOFF).
2At least one tool length offset component has been programmed twice in one block (with TOFFL).
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
187