Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 385

Measure tool:
Tool type impermissible for calibration (adjustment) of the tool probe.
61315 [Channel %1: ] Block %2: Check position of cutting edge
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When measuring the workpiece in turning, cutting edge positions 7 and 8 are allowed for probe type 580.
Cutting edge positions 5 and 6 are also possible in special applications, such as measuring at the counterspindle.
Remedy: When measuring the workpiece in turning, check the cutting edge position of the probe in the tool list.
When measuring the tool in turning with orientable toolholders, the active cutting edge position of the probe is
evaluated.
In this case, the active one must be checked.
61316 [Channel %1: ] Block %2: Center and radius cannot be determined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No circle can be calculated from the measured points, as all measured points lie on a straight line.
Remedy: Program change
61317 [Channel %1: ] Block %2: Check number of circle calculation points
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameterization faulty; requires 3 or 4 points to calculate the center point.
Remedy: Change parameterization of CYCLE116.
61318 [Channel %1: ] Block %2: Check weighting factor
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check parameter (_K)
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check parameter (FW)
61319 [Channel %1: ] Block %2: Check call parameter CYCLE114
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Check call parameter CYCLE114.
61320 [channel %1: ] block %2: check tool name / number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check parameters _TNUM, _TNAME.
Bei 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check parameter S_TNAME .
With active tool management, parameter S_TNAME is empty or
the specified tool name is unknown to the tool management.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
385