Configuring A Drive Unit - Siemens SINAMICS DCM Operating Instructions Manual

Commissioning
8.5 Commissioning with the STARTER commissioning tool
8.5.2.2

Configuring a drive unit

Note
The STARTER must be offline for the sequence described below.
As a general rule, the drive unit can also be added to the project in online mode of the
STARTER via "Browse accessible nodes".
In the project navigator, open the tree element that contains your drive unit.
Figure 8-16 Configuring the project navigator drive unit
⇒ In the project navigator, click the plus sign next to the drive unit that you want to configure.
The plus sign changes into a minus sign and the options for configuring the drive unit appear
as a directory tree under the drive unit.
⇒ Double click Configure drive unit
264
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A