Toyota 3S-GE Repair Manual page 123

EG-1 O9
ENGINE — ENGINE MECHANICAL
\
/*
PI678l
A @
"/
§\/'\
\ sf
Aw
// . 4 v>
é.' / Z51
' @\ '€>
> \
n._< 7 _Q\_
\"< x4:Uxi(2/'-
> 7}' '
-5 )>W\ _ Q"
\
F' \/
s
ZIQKII
.__
ta";
Q')? \ Q
//r/IQ \
1 OQ/I X" I
( " D / »
K)_\
/
,3/l
H6765
ST202 4 \-</ <
.;%/QC
W5
éiii
~
/(. c
P16764
SW20
,
:1
Ii at
W»!-.3
#:-
r? "'-1
Q . 8 0
\° PIBO35
Hexagon
Wrench
/ P1673';
(d)
6.
7.
8.
(8)
(b)
(0)
Install the head cover with the 10 seal washers and
bolts. Uniformly tighten the bolts in several passes.
Torque: 6.0 N-m (61 kgf-cm. 53 in.-Ibf)
HINT: Each bolt length is indicated in the illustration.
Bolt length:
A 25 mm (0.98 in.)
B 50 mm (1.97 in.)
INSTALL NO.4 TIMING BELT COVER
Install the timing belt cover with the 3 bolts.
Torque: 8.0 N-m (82 kgf-cm, 71 in.-Ibf)
INSTALL NO.3 TIMING BELT COVER
ST202:
Install the timing belt cover with the 5 bolts.
Torque: 8.0 N-m (82 kgf-cm, 71 in.-Ibf)
SW20:
Install the timing belt cover with the 6 bolts.
Torque: 8.0 N-m (82 kgf-cm. 71 in.-Ibf)
SET TIMING BELT TENSIONER
Using a press, slowly press in the push rod using 981
— 9,807 N (100 — 1,000 kgf, 220 — 2,205 Ibf) of
force.
Align the holes of the push rod and housing, pass a
1.27 mm hexagon wrench through the holes to keep
the setting position of the push rod.
Release the press.