Toyota 3S-GE Repair Manual page 329

EG-315
ENGINE — COOLING SYSTEM
E5617 —llI
WATER PUMP REMOVAL
(See Components for Removal and Installation)
1. DRAIN ENGINE COOLANT
2. REMOVE TIMING BELT
(See steps 1 to 6 and 8 to 13 on pages EG—49 to 54)
SST , 3. REMOVE EXHAUST CAMSHAFT TIMING PULLEY
. a / 4' (a) Using SST loosen the pulley bolt.
¢ i ' ssr 09960-10010 9962-01000, 099s3—o1ooo)
' .
V 4} (0
(b) Remove the bolt, timing pulley and knock pin.
T vgéwlf
\ 'Q/*1'. ,
'"f1
\')@ l
\
P16935
4. REMOVE NO.1 IDLER PULLEY
(a) Turn the No.1 idler pulley bolt to obtain the specified
Fulcrum _ ,' torque or less, and remove the 3.0 mm hexagon
i-e"9th ' wrench.
Q
"Q2: a
@>\¢\
Torque:
@ " E'-£353" 69 N-m (700 kgf-cm. 51 mm)
wremh 4a N-m (490 kgf-cm. as ft-Ibf) for ssr
ssT 'ea N j HINT (On vehicle):
N58,, O Use SST.
/
Remove
K
£%{V%,
96% Q
Q QT
/@
\
SST 09249-63010
I Use a torque wrench with a fulcrum length of
340 mm (13.39 in.).
(b) Remove the pivot bolt, pulley and plate washer.