Toyota 3S-GE Repair Manual page 393

ENGINE — LUBRICATION SYSTEM EG_3-,9
OIL PRESSURE CHECK *
Recommended Viscosity (SAE) : 1 mu-it
. CHECK ENGINE OIL QUALITY
____—_——— Check the oil for deterioration, entry of water, dis-
I . - - -
¥—_I 1 coloring or thinning.
If the quality is visibly poor, replace the oil.
"c-29 -we -7 4 16 27 as - ,
"F -20 0 20 40 so ao 100 0" 9"ad9- _
W645 Recommended viscosity is as shown in the
vq'
v-:5
I:..
I .9!»
illustration.
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE grade SGI or multigrade engine oil.
2. CHECK ENGINE OIL LEVEL
The oil level should be between the "L" and "F" marks
on the dipstick.
lf low, check for leakage and add oil up to "F" mark.
P15653
iéa
\ ,
S'
3. REMOVE OIL PRESSURE SWITCH, AND INSTALL
ST202 Oil Pressure'Switc_h' '
J ' 7 \/ - oii_ PRESSURE GAUGE
_¢ (F ' (a) sw2o;
I Disconnect the throttle body from the ACIS valve.
3 (b) Remove the oil pressure switch.
/ W HINT (ST202): Use SST.
' sst 09816-30010
l
'Z' P18030
OH Pressure Gauge/ (c) lnstall the oil pressure gauge.
vv T
J _,_._ \> /
I
\
_ J':
L/—J
2
ti' P~
S
4. WARM UP ENGINE
Allow the engine to warm up to normal operating
temperature.
5. CHECK OIL PRESSURE '
Oil pressure:
At idle
29 kPa (0.3 kgf/cm', 4.3 psi) or more
mm At 5.000 rpm
245 — 490 kPa
(2.5 - 5.0 kgf/cm', 36 — 71 psi)
6. REMOVE OIL PRESSURE GAUGE, AND REINSTALL
OIL PRESSURE SWITCH
__ '\ Apply adhesive to 2 or 3 threads of the oil pressure
it h
;'((€@(... :t:.:...
( :
Part No. 08833—O0080, THREE BOND 1344.
Adhesive LOCTITE 242 or equivalent
W, 7. START ENGINE. AND CHECK FOR OIL LEAKS