Toyota 3S-GE Repair Manual page 167

EG-153
ENGINE — ENGINE MECHANICAL
\ ' ¢ Yé' — ((\ ! . ! f "
$14
_ gr \
,@e;rN®)
EM8020
/\ - 19%'
\
- /
P0533?
Front Mark
(Cavity)
€-¥>{ /
K
\
Q ( \ \ ( : r ; * ' 4 <>~
as U' "
Front I'
Pl569fi P'l5?O8
Push
ZH945
Front Mark
(Protrusion)
5'
1 \
Front \
I N
4:20'
EM7985
\{/
i t
'_ /.
.. V L I /
a '\
EM7934
)
/\ 6-
gié' la)
(b)
la)
(bl
(C)
id)
(6)
Check the crankshaft thrust clearance.
I Using a dial indicator, measure the thrust clear-
ance while prying the crankshaft back and forth
with a screwdriver.
Standard thrust clearance:
0.020 — 0.220 mm (0.0008 — 0.0087 in.)
Maximum thrust clearance:
0.30 mm (0.0118 in.)
If the thrust clearance is greater than maximum, re-
place the thrust washers as a set.
INSTALL PISTON AND CONNECTING ROD
ASSEMBLES
Cover the connecting rod bolts with a short piece of
hose to protect the crankshaft from damage.
Using a piston ring compressor, push the correctly
numbered piston and connecting rod assemblies into
each cylinder with the front mark of the piston facing
forward. '
INSTALL CONNECTING ROD CAPS
Match the numbered connecting rod cap with the
connecting rod.
lnstall the connecting rod cap with the front mark
facing forward.
Apply a light coat of engine oil on the threads and
under the nuts of the connecting rod cap.
Install and alternately tighten the 2 cap nuts in several
passes.
Torque: 67 N-m (680 kgf-cm. 49 ft-Ibf)
Check that the crankshaft turns smoothly.