Toyota 3S-GE Repair Manual page 112

EG—9B
ENGINE —— ENGINE MECHANICAL
\c
\'®.§J
J
P1668?
A AMT 3'-"'
t)
tfw
_/(—) Z
*1
g
71*
* / ......
u
\_,
0 \
3 76 .
(7 U /J
O
J
A' Pl6688
I 1
"°
'fig \ \®.\
)1' 1 'Q9
$9
._
Y' (al
\ (bl
"I 15)' \'
P16716
(d) Install the bearing caps.
(See step 2 on page EG—107)
Torque: 19 N-m (190 kgf-cm, 14 ft-Ibf)
NOTICE: Do not turn the camshaft.
(e) Remove the bearing caps.
(f) Measure the Plastigage at its widest point.
Standard oil clearance:
0.025 — 0.062 mm (0.0010 — 0.0024 in.)
Maximum oil clearance:
0.08 mm (0.0031 in.)
If the oil clearance is greater than maximum, replace
the camshaft. If necessary, replace the bearing caps
and cylinder head as a set.
(g) Completely remove the Plastigage.
F. Inspect camshaft thrust clearance
Install the camshaft. (See step 2 on page EG—107)
Using a dial indicator, measure the thrust clearance
while moving the camshaft back and forth.
Standard thrust clearance:
0.100 — 0.240 mm (0.0039 — 0.0094 in.)
Maximum thrust clearance:
0.30 mm (0.0118 in.)
If the thrust clearance is greater than maximum, re-
place the camshaft. If necessary, replace the bearing
caps and cylinder head as a set.