Toyota 3S-GE Repair Manual page 64

EG'5° ENGINE — ENGINE MECHANICAL
1/ / .
E6 \\~Clam'p
P
\
/._\ /' '
Engine 7k}
Hanger 7' Engine
A' \ ' Wire
_ ., as Bracket
I 'gm.
\ \ i\\'F)'$'§'\'
U' /A -
~.> -l t
P168116
Ci' / J'/(¢
J
/
. Z
/ ,_
@ U
\l-t I'
'Iv
lb *4
R) 7: —J
- v_. 1
PIS738
was / 2
2) -
%
PI 68313
t;@
Aii ~
73% I it
(b) Check that the timing marks of the camshaft timing
5'
j
3. SW20:
REMOVE RH FRONT ENGINE HANGER AND ENGIN
WIRE BRACKET
(a) Disconnect the engine wire from the clamp on th
wire bracket.
(b) Remove the 4 bolts, wire bracket and engine hange
( 4. REMOVE NO.2 TIMING BELT COVER I
i '
Z771» I
» ~ ii l
\ \ - I
\ s |
Remove the 5 bolts, timing belt cover and gasket.
5. SET NO.1 CYLINDER TO TDC/COMPRESSION
timing mark '0' of the No.1 timing belt cover.
pulleys are aligned with the timing marks of the No.4
timing belt cover.
If not, turn the crankshaft 1 revolution (360°).
(a) Turn the crankshaft pulley, and align its groove witl'I
6. DISCONNECT TIMING BELT FROM CAMSHAFT
TIMING PULLEYS
HINT (Re—using timing belt): Place matchmarks on
the timing belt and camshaft timing pulleys, and place
a matchmark on the timing belt to match the end of
the No.1 timing belt cover.