10.4.1 Auto-View
The upper left viewport will autoview each secondary recon. The primary recon will display only
if assigned to a viewport
10.4.2 Series Binding
If you have series binding in the viewports, and use it or the next/previous series buttons to
change the series displayed within the viewport.
10.4.3 Expanded Mode
When you have expanded any of the 4 512x512 viewports to 1024x1024 mode, so that a single
viewport takes up the full viewport area, the viewport control button changes to a single button,
and only a single series at a time can be displayed.
10.4.4 Viewport Priority
The priority for images being displayed in the viewports:
1. Any task (recon, reformat or AW) opened by clicking on a task bar.
2. Any reformat auto-view by volume – where DMPR is set to show the entire volume in all 4
viewports as it is being acquired and built.
3. Any standard auto-view set up for a reconstruction or reformat task, where the auto-view is
displayed in the upper left viewport.
4. Any image assigned to a viewport using a viewport selection button.
10.5 Image Tools Column
The right column of the list includes a menu of image-related tools and options.
Refer to the View Images chapter for information on using the image-related tools and options.
Chapter 17 Data Management
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
571