Remove Dvd Ram Cartridge - GE Revolution CT User Manual

5.6 Remove DVD RAM Cartridge

Use this procedure to remove media from a DVD RAM cartridge for use in the Peripheral Media
Tower equipped with a single DVD multimedia drive.
•
For use with Operator Console utilizing a single bay Peripheral Media Tower (DVD-
Multimedia drive only).
•
DVD-Multimedia drives cannot accept cartridge type DVD-RAM media. Use the following
procedure for removing the DVD-RAM media from the cartridge if so equipped.
• Handle bare DVD-RAM media with care. Do not touch the recording surface. Fingerprints,
dirt, dust and scratches on the recording surface can destroy previously recorded data and
prevent recording of additional data.
• If required, use only approved CD/DVD media disk cleaning solution (not supplied) to clean
any disks that become contaminated with fingerprints, dirt and dust. Do not use alcohol,
antistatic or other cleaning solutions.
• Take care with placing bare DVD-RAM media without cartridge.
•
Always return a DVD-RAM media to its cartridge for storage.
NOTE: In the case of double-sided DVD-RAM media, take care to insert the media back into
cartridge with the same orientation as it was removed. If media is inserted upside
down, any labeling on the cartridge will not be consistent with data on the disk.
Follow the procedure and precautions outlined below to remove the disc from the cartridge.
1. Remove the disc.
a. Push and remove the cartridge-locking pin with a sharp-tipped object, such as a ballpoint
pen.
b. Open the cover by pushing the sharp-tipped object into the gap on the left-front side of
the cartridge.
2. Do not touch the recording surface. Fingerprints, dirt, dust and scratches on the recording
surface can destroy previously recorded data and prevent recording of additional data.
3. Open the cover with care. If you damage the cover, you may not be able to close it again.
4. Use a felt-tipped marker to write on the label. Never stick a new label on a disc.
5. Clean dirty discs only with the special DVD-RAM disc cleaner and cleaning fluid (not
included).
6. Always return a disc to its cartridge for storage.
7. Make sure the printed side of the shutter and the printed side of the disc is facing the same
side when returning the disc to its cartridge. Also, note the setting of the write-protect tab.
8. Place bare DVD-RAM media back in cartridge for storage.
9. Close cartridge lid once DVD-RAM media is fully inserted into cartridge.
Chapter 17 Data Management
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
541