4. Record a message set (pre-message and post-message).
NOTE:
To save a language, at least one message set must be recorded within the
language.
5. Click [Save].
3.2 Delete an Auto Voice language
Use this procedure to delete user‐defined languages.
1. From the image monitor, click
Protocol Management , then Auto Voice Management .
2. Click
Auto Voice Management window opens.
The
3. Select the language to delete.
Delete Language from the drop-down menu.
4. Select
○
The language will not be deleted if it is a factory installed language.
○
Deleting the language will remove all user‐defined Auto Voice messages.
3.3 Record an Auto Voice message
The system has three pre-recorded voice message sets in nine selectable languages that
cannot be deleted.
Chapter 18 Protocols
Illustration 4: Message Record window
.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
585