Set The Dose Check Av Exceeding User Role - GE Revolution CT User Manual

3 Set the Dose Check AV Exceeding User Role

NOTE: Refer to the
enterprise server, and defining local or enterprise groups.
The AV Exceeding User role is assigned at the group level. Users assigned to a group with this
role can approve scanning when an AV value has been exceeded. We recommend that only
one user be assigned to the AV Exceeding User group after having discussions with the
radiologist, physicist and department managers.
1. From the image monitor, click
Mode menu, click Access Controls , then User Admin Tool .
2. From the
EA3 Administration window, enter your username and password
3. From the
NOTE: The user should be someone with administrative privileges.
Local Users tab.
4. Click the
Local Users tab, click [Add Local User].
5. From the
Add User window, enter the following:
6. From the
○ User ID
Full Name
○
○ Password
○ Confirm Password
NOTE: The
7. Click [Add User].
Groups tab.
8. Click the
Groups tab, click [Add Local Group].
9. From the
NOTE: Alternately, the system can be configured for enterprise groups if enterprise
authentication has been enabled. Refer to the
information on configuring enterprise authentication.
Add Local Group window, type a unique group name.
10. From the
11. Click [Add Group].
○
The group is highlighted in the
○
All information and buttons in the center panel refer to the highlighted group.
Roles area, select Dose Check AV Exceeding User and click [Apply Roles].
12. From the
○
A green label confirms the applied roles.
○
An error message displays if it is unsuccessful.
Chapter 7 Dose Check
Access Controls chapter for instructions on setting local users, an
.
User ID must be unique from others used on the system.
Local Groups list.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Access Controls chapter for
141