Exam Workflow Procedures - GE Revolution CT User Manual

Element
[Confirm Settings]
[Close Exam]
Table 7: Scan Setup window — Right-click Selections
Element
Duplicate Series
Delete Series
Add Group
Add Smart Prep Group
Delete Group
Split and Link
Split
Link All
Unlink All
Rename
Undo
NOTE: Unlinked groups are reconstructed as separate volumes for the primary and each
secondary recon. The primary recon of linked groups is reconstructed as a separate
volume for each table position. For secondary recons, all table positions are
reconstructed as a contiguous volume when

3.3 Exam Workflow Procedures

This is an overview of the steps necessary for a patient scan, from patient set up to image
management.
1. Set up and position the patient.
2. Set up the patient's information.
3. Select a protocol.
4. Acquire a Scout scan.
5. Acquire the scan data.
a. Set the Scan Parameters.
b. Adjust the Graphic Rx.
c. Set the Timing Parameters.
Chapter 11 Scan
Ends prescription preview mode.
NOTE: This is not available if the patient has not been landmarked or if invalid parameters
Scan Settings window.
exist in the
Closes the patient exam session.
Right-click on a series task to duplicate it.
Right-click on a series task to delete it.
Right-click on a group task to add an additional group.
Right-click on a Smart Prep group task to add an additional group.
Right-click on a group task to delete it.
One or More table position prescription within a single physical scan group and sepa‐
Splits any
rates them into individual physical scan groups; then the start and end between groups are linked
and contiguous.
Splits any One or More table position prescription within a single physical scan group and sepa‐
rates them into individual physical scan groups.
Links all scan groups in the series. Only the start of the first group and end of the last group can
be adjusted. The start and end between groups when adjusted will force the groups to be contig‐
uous. Use linked groups to adjust the location of a scan rotation boundary while keeping the
groups contiguous.
Unlinks all scan groups in the series, allowing them to be moved independently.
Rename the selected task.
Removes the last recorded right menu action.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Description
Description
Add Recon is set to All .
249