GE Revolution CT User Manual page 669

Number English Operator Message
Table position detected outside of scan start and end posi‐
tions during AEC scan.
17
If problem persists, please contact your service representa‐
tive.
X-ray exposure terminated by backup timer instead of nor‐
18 mal control.
Please contact your service representative.
Pause failed. Please retry Pause, press Stop Scan, or
19
press E-stop.
20 Stop Scan failed. Please retry or press E-stop.
Laser alignment lights are automatically turned off during
21
scanning.
22 Scan has completed but the injection is still in progress.
Cannot open a new review session while on scan progress
screen. Please complete the scan in progress and then
23
open the desired session.
Close if any of the following application(s) are running:
Protocol Management is not available while in an active
24 scan session.
Close if any of the following application(s) are running:
Auto Gating Management is not available while in an active
25 scan session.
Close if any of the following application(s) are running:
Auto Voice management is not available while in an active
26 scan session.
Close if any of the following application(s) are running:
User Admin application is not available while in an active
27 scan session.
Close if any of the following application(s) are running:
Dose Check Management is not available while in an active
28 scan session.
Close if any of the following application(s) are running:
Audit Tool application is not available while in an active
29 scan session.
Close if any of the following application(s) are running:
Switch User cannot be completed at this time. Please com‐
30 plete the scan in progress and then switch users.
Close if any of the following application(s) are running:
Fast Cal application is not available while in an active scan
31 session.
Close if any of the following application(s) are running:
Scan cannot be resumed as a irrecoverable system error
has occurred.
32
Please select Done Scanning and start a new patient ses‐
sion or restart the system.
Appendix A Operator Messages
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Translated Operator Message
669