Table of Contents
Advertisement
Element
Start Location
End Location
Range
Number of Image
SFOV
DFOV
A/P center
R/L center
Auto Scan
4.5 Scan parameters workflow
Use this procedure to set scan parameters according to your patient's size and anatomy. These
parameters will determine the image quality you achieve. Always make sure to remove any
objects that may cause artifacts. Review the scout image for objects that may cause artifacts.
Considerations
•
If the patient orientation is different from the previous scan, the following message is seen:
Patient orientation/position has changed from the previous series. Please verify the
orientation/position of this series is as intended or change the orientation/position, if needed.
Chapter 11 Scan
Illustration 21: Anatomy Selection collection
The start location for the scan.
The end location for the scan.
Range of images.
Number of image acquisitions.
Define how much anatomy is scanned.
Allows you to target a particular piece of anatomy for display and determines how much of
the SFOV is reconstructed into an image.
Allows you to define the DFOV center of the image in the Anterior/Posterior directions rela‐
tive to the SFOV.
Allows you to define the DFOV center of the image in the Right/Left directions relative to
isocenter of the SFOV.
Shows whether
Auto Scan is on or off.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Description
277
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Revolution CT and is the answer not in the manual?
Questions and answers
need a part number for the Integrated Cardiac Patient Monitor, patient grounding strap + cable
How do I clear Ge Revolution collision sensor
To clear the collision sensor on a GE Revolution CT, remove any obstructions detected by the sensors located beneath the front and back of the table. Once the area is clear, you can continue positioning the table.
This answer is automatically generated