Batch Options - GE Revolution CT User Manual

3.1.4.2 Batch Options

The Batch Options change depending on the type of series being used in the reformat.
Table 2: Oblique settings
For this setting:
Type
Number of images
Slice thickness
Interval
FOV
Rendering Mode
Table 3: Rotate settings
For this setting:
Type
Number of images
Angle between images
Slice Thickness
FOV
Rendering Mode
Preview tool
Before you save or print a batch, you can preview what the batch will look like using the Preview
tool in the Batch Options section of the
424
Select or set:
This setting is read-only (set in the Protocol settings)
Set the number of images to include in the reformat. This num‐
ber updates based on slice thickness, slice interval, and the start
and end locations.
Set the slice thickness.
Set the slice interval.
Set the field of view. The value is specified in centimeters (cm).
Select the rendering mode.
Select or set:
This setting is read-only (set in the Protocol settings)
Set the number of images. This value updates based on slice
thickness, angle between images and start and end location.
Set the angle between images.
Set the slice thickness.
Set the field of view
Select the rendering mode.
Reformat Settings panel.
3 Direct Multi Planar Reformat (DMPR)
Revolution CT User Manual
Direction 5480385-1EN, Revision 1