Table of Contents
Advertisement
Number English Operator Message
Serious error detected during table operation. Please stop
all table motions immediately using E-stop.
5
Please select Done Scanning and perform a Scan Hard‐
ware Reset from the Service Tools menu.
If problem persists, contact your service representative.
Table is in service mode.
6
All table motion shall be controlled from the table service
panel. Gantry control panels will be disabled.
Table 5: General System Operator Messages
Number English Operator Message
Can't establish Insite connection. Please check your net‐
1
work configuration.
Image database is corrupted.
2
Please perform a System Restart from the Mode menu.
If problem persists, contact your service representative.
System firewall is not working or not configured. System is
3
vulnerable to security threats.
System detected a mismatch on the displayed information.
4
If the problem persists, please perform a Scan Hardware
Reset from the Service Tools menu.
System detected internal communication error.
Please perform a Scan Hardware Reset from the Service
5
Tools menu. If problem persists, contact your service repre‐
sentative.
Low image space. Please remove images and empty the
6
recycle bin.
To run SPR Snap first press Revisit Settings.
7
Close if any of the following application(s) are running:
Appendix A Operator Messages
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Translated Operator Message
Translated Operator Message
673
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Revolution CT and is the answer not in the manual?
Questions and answers
need a part number for the Integrated Cardiac Patient Monitor, patient grounding strap + cable
How do I clear Ge Revolution collision sensor
To clear the collision sensor on a GE Revolution CT, remove any obstructions detected by the sensors located beneath the front and back of the table. Once the area is clear, you can continue positioning the table.
This answer is automatically generated