Electrical Safety - GE Revolution CT User Manual

6 Electrical Safety

Chapter 3 Safety
DANGER
ELECTRICAL SHOCK HAZARD. AVOID ALL CONTACT WITH ANY
ELECTRICAL CONDUCTOR. DO NOT REMOVE OR OPEN SYSTEM COVERS
OR PLUGS. INTERNAL CIRCUITS USE HIGH VOLTAGE CAPABLE OF
CAUSING SERIOUS INJURY.
AN ELECTRICAL HAZARD MAY EXIST IF ANY LIGHT, MONITOR, OR VISUAL
INDICATOR STAYS ON AFTER THE SYSTEM IS SHUT DOWN. TO PREVENT
POSSIBLE INJURY, TURN OFF THE MAIN POWER SUPPLY WALL SWITCH,
AND CONTACT YOUR SERVICE OFFICE IMMEDIATELY.
DANGER
NO USER SERVICEABLE PARTS. REFER SERVICE TO QUALIFIED SERVICE
PERSONNEL. ONLY ALLOW PEOPLE WHO KNOW THE PROPER
PROCEDURES, AND USE OF THE PROPER TOOLS, TO INSTALL, ADJUST,
REPAIR, OR MODIFY THE EQUIPMENT.
TO GUARANTEE SAFE, RELIABLE EQUIPMENT PERFORMANCE, PREPARE
THE SITE ACCORDING TO GE HEALTHCARE REQUIREMENTS. THIS
INCLUDES MAKING SURE THE EQUIPMENT IS CONNECTED TO A SUPPLY
MAINS WITH A PROTECTIVE EARTH. IF YOU HAVE ANY QUESTIONS
ABOUT THESE REQUIREMENTS, CONTACT GE HEALTHCARE.
FUSES BLOWN WITHIN 36 HOURS OF BEING REPLACED MAY INDICATE
MALFUNCTIONING ELECTRICAL CIRCUITS WITHIN THE SYSTEM. HAVE
THE SYSTEM CHECKED BY QUALIFIED SERVICE PERSONNEL, AND DO
NOT ATTEMPT TO REPLACE ANY FUSE.
DANGER
INFORMATION ON INTERNAL GANTRY COMPONENTS IS PROVIDED FOR
USER EDUCATION. THE GANTRY CONTAINS DANGEROUS VOLTAGES
AND MOVING PARTS.
TO PREVENT ELECTRICAL SHOCK OR CRUSHING INJURIES, DO NOT
REMOVE COVERS OR ENTER THE GANTRY. ONLY TRAINED, QUALIFIED
SERVICE PERSONNEL MAY REMOVE GANTRY OR OTHER EQUIPMENT
COVERS.
DANGER
ELECTRICAL FIRE. CONDUCTIVE FLUIDS THAT SEEP INTO THE ACTIVE
CIRCUIT COMPONENTS OF THE SYSTEM MAY CAUSE SHORT CIRCUITS
THAT CAN RESULT IN ELECTRICAL FIRES. THEREFORE, DO NOT PLACE
ANY LIQUID OR FOOD ON ANY PART OF THE SYSTEM.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
65