AudioCodes Mediant 800B MSBR User Manual page 482

3. Configure call forwarding per port according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 31-4: Call Forward Table Parameter Descriptions
Parameter
Index
[FwdInfo_Index]
Module
[FwdInfo_Module]
Port
[FwdInfo_Port]
Port Type
[FwdInfo_PortType]
Type
CLI: type
[FwdInfo_Type]
Forward Destination
CLI: destination
[FwdInfo_Destination]
No Reply Time
CLI: no-reply-time
[FwdInfo_NoReplyTime]
User's Manual
(Read-only) Displays the index number of the table record.
(Read-only) Displays the module number on which the port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
Defines the condition upon which the call is forwarded.

[0] Deactivate = (Default) Don't forward incoming calls.

[1] On Busy = Forward incoming calls when the port is busy.

[2] Unconditional = Always forward incoming calls.

[3] No Answer = Forward incoming calls that are not answered within
the time specified in the 'No Reply Time' field.

[4] On Busy or No Answer = Forward incoming calls when the port is
busy or when calls are not answered within the time specified in the
'No Reply Time' field.

[5] Don't Disturb = Immediately reject incoming calls.
Defines the telephone number or URI (<number>@<IP address>) to
where the call is forwarded.
Note: If this parameter is configured with only a telephone number and a
Proxy isn't used, this forwarded-to phone number must be specified in
the Outbound IP Routing table (see ''Configuring Outbound IP Routing
Table'' on page 397).
If you have set the 'Type' parameter for this port to No Answer or On
Busy or No Answer, then configure the number of seconds the device
waits before forwarding the call to the specified phone number.
482
Mediant 800B MSBR
Description
Document #: LTRT-12813