AudioCodes Mediant 800B MSBR User Manual page 281

User's Manual
Parameter
Username
CLI: username
[IPGroup_Username]
Password
CLI: password
IPGroup_Password]
Version 6.8
The device first uses the parameter's settings as a
matching characteristic (input) to classify the incoming
INVITE to an IP Group (source IP Group) in the
Classification table. Once classified, the device uses the
parameter for routing the call. For example, if set to To, the
URI in the To header of the incoming INVITE is used as a
matching characteristic for classifying the call to an IP
Group in the Classification table. Once classified, the
device uses the URI in the To header as the destination.

[-1] Not Configured (default)

[0] From

[1] To

[2] Request-URI

[3] P-Asserted - First Header

[4] P-Asserted - Second Header

[5] P-Preferred

[6] Route

[7] Diversion

[8] P-Associated-URI

[9] P-Called-Party-ID

[10] Contact

[11] Referred-by
Notes:

The parameter is applicable only when classification is
done according to the Classification table.

If the configured SIP header does not exist in the
incoming INVITE message, the classification of the
message to a source IP Group fails.

If the device receives an INVITE as a result of a REFER
request or a 3xx response, the incoming INVITE is
routed according to the Request-URI. The device
identifies such INVITEs according to a specific prefix in
the Request-URI header, configured by the
SBCXferPrefix parameter. Therefore, in this scenario,
the device ignores this parameter setting.
Defines the shared username for authenticating the IP
Group, when the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By
default, no username is defined.
Notes:

This parameter is applicable only to Server-type IP
Groups and when the 'Authentication Mode' parameter
is set to SBC as Server (i.e., authentication of servers).

To specify the SIP request types (e.g., INVITE) that
must be challenged by the device, use the
'Authentication Method List' parameter.
Defines the shared password for authenticating the IP
Group, when the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By
default, no password is defined.
281
21. Control Network
Description
Mediant 800B MSBR