Mediant 800B MSBR
Parameter
Route By
CLI: route-by
[Test_Call_RouteBy]
IP Group ID
CLI: ip-group-id
[Test_Call_IPGroupID]
Destination Address
CLI: dst-address
[Test_Call_DestAddress]
Destination Transport Type
CLI: dst-transport
[Test_Call_DestTransportType]
SRD
CLI: srd
[Test_Call_SRD]
Application Type
CLI: application-type
[Test_Call_ApplicationType]
QoE Profile
CLI: qoe-profile
[Test_Call_QOEProfile]
Version 6.8
Defines the type of routing method. This applies to incoming and
outgoing calls.
[0] GW Tel2IP = (Default) Calls are matched by (or routed to)
an SRD and Application type (defined in the SRD and
Application Type parameters below).
[1] IP Group = Calls are matched by (or routed to) an IP Group
ID.
[2] Dest Address = Calls are matched by (or routed to) an SRD
and application type.
Notes:
For REGISTER messages, the option [0] cannot be used as
the routing method.
For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:
This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.
This IP Group is used for incoming and outgoing calls.
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Defines the transport type for outgoing calls.
[-1] = Not configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Defines the SRD for the endpoint.
The default is SRD 0.
Note: This parameter is applicable only if the 'Route By'
parameter is set any option except [1] (IP Group).
Defines the application type for the endpoint. This, in effect,
associates the IP Group and SRD to a specific SIP interface. For
example, assume two SIP Interfaces are configured in the SIP
Interface table where one is set to "GW & IP2IP" and one to
"SBC" for the 'Application Type'. If this parameter is set ot "SBC",
the device uses the SIP Interface set to "SBC".
[0] GW & IP2IP (default)
[2] SBC
Assigns a QoE Profile to the test call. To configure QoE Profiles,
see ''Configuring Quality of Experience Profiles'' on page 248.
741
62. Testing SIP Signaling Calls
Description
Mediant 800B MSBR