Mediant 800B MSBR
Parameter
[PulseDialGenerationInterDigi
tTime]
67.10.12
Trunk Groups and Routing Parameters
The routing parameters are described in the table below.
Parameter
Trunk Group Table
Web: Trunk Group Table
EMS: SIP Endpoints > Phones
CLI: configure voip > gw hunt-or-trunk-
group TrunkGroup
[TrunkGroup]
Hunt Group Settings
Web: Hunt Group Settings
EMS: SIP Routing > Hunt Group
CLI: configure voip > gw hunt-or-trunk-
group trunk-group-setting
[TrunkGroupSettings]
Web: Channel Select Mode
EMS: Channel Selection Mode
CLI: ch-select-mode
[ChannelSelectMode]
Version 6.8
Defines the inter-digit duration (time between consecutively dialed
digits) for FXO pulse dial generation.
The valid value range is 300 to 1500 (in msec). The default is 700.
Note: For this parameter to take effect, a device reset is required.
Table 67-69: Routing Parameters
This table parameter configures and activates the device's
endpoints/Trunk channels. This is done by defining
telephone numbers and assigning them to Trunk Groups.
The format of the ini file table parameter is as follows:
[TrunkGroup]
FORMAT TrunkGroup_Index =
TrunkGroup_TrunkGroupNum, TrunkGroup_FirstTrunkId,
TrunkGroup_FirstBChannel, TrunkGroup_LastBChannel,
TrunkGroup_FirstPhoneNumber, TrunkGroup_ProfileId,
TrunkGroup_LastTrunkId, TrunkGroup_Module;
[\TrunkGroup]
For a description of this table, seeConfiguring Trunk Group
Table on page 365.
Note: Trunk Group ID 1 is denoted as 0 in the table.
This table parameter configures the rules for channel
allocation per Trunk Group.
The format of the ini file table parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,
TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroup,
TrunkGroupSettings_MWIInterrogationType,
TrunkGroupSettings_TrunkGroupName;
[\TrunkGroupSettings]
For a description of this table, see ''Configuring Hunt Group
Settings'' on page 367.
Defines the method for allocating incoming IP-to-Tel calls to
a channel. This parameter applies to the following:
All Trunk Groups configured without a channel select
mode in the Trunk Group Settings table (see ''Configuring
Hunt Group Settings'' on page 367).
963
67. Configuration Parameters Reference
Description
Description
Mediant 800B MSBR