Configuring Inbound Ip Routing Table - AudioCodes Mediant 800B MSBR User Manual

Parameter
28.3

Configuring Inbound IP Routing Table

The Inbound IP Routing table lets you configure up to 120 inbound call routing rules:

For IP-to-IP routing: The table is used to identify an incoming call as an IP-to-IP call
and subsequently, to assign the call to an IP Group, referred to as a source IP Group.
These IP-to-IP calls can later be routed to an outbound destination IP Group (see
Configuring Outbound IP Routing Table on page 397).

For IP-to-Tel routing: This table is used to route incoming IP calls to Trunk Groups.
The specific channel pertaining to the Trunk Group to which the call is routed is
determined according to the Trunk Group's channel selection mode. The channel
selection mode can be defined per Trunk Group (see ''Configuring Hunt Group
Settings'' on page 367) or for all Trunk Groups using the global parameter
ChannelSelectMode.
User's Manual
alternative routing is enabled. This is because the subsequent
index entries are defined with a Forking Group number that is
lower than that of index entry 1.

Table index entry 1 is defined with Forking Group "1", index
entry 2 with Forking Group "2", and index entries 3 and 4 with
Forking Group "1": The device first sends the call according to
index entries 1, 3, and 4 (all belonging to Forking Group "1"),
and if the destination is unavailable and alternative routing is
enabled, the device sends the call according to index entry 2.

Table index entry 1 is defined with Forking Group "1", index
entry 2 with Forking Group "3", index entry 3 with Forking
Group "2", and index entry 4 with Forking Group "1": The
device first sends the call according to index entries 1 and 4 (all
belonging to Forking Group "1"), and if the destination is
unavailable and alternative routing is enabled, the device sends
the call according to index entry 2 (Forking Group "3"). Even if
index entry 2 is unavailable and alternative routing is enabled,
the device ignores index entry 3 because it belongs to a
Forking Group that is lower than index entry 2.
Notes:

To enable Tel-to-IP call forking, set the 'Tel2IP Call Forking
Mode' (Tel2IPCallForkingMode) parameter to Enable.

You can configure the device to immediately send the INVITE
message to the first member of the Forking Group (as in
normal operation) and then only after a user-defined interval,
send (simultaneously) the INVITE messages to the other
members. If the device receives a SIP 4xx or 5xx in response
to the first INVITE, it immediately sends INVITEs to all the other
members, regardless of the interval. To configure this feature,
use the ForkingDelayTimeForInvite ini file parameter.

You can implement Forking Groups when the destination is an
LDAP server or a domain name using DNS. In such scenarios,
the INVITE is sent to all the queried LDAP or resolved IP
addresses, respectively. You can also use LDAP routing rules
with standard routing rules for Forking Groups.

When the UseDifferentRTPportAfterHold parameter is enabled,
every forked call is sent with a different RTP port. Thus, ensure
that the device has sufficient available RTP ports for these
forked calls.
406
Mediant 800B MSBR
Description
Document #: LTRT-12813