AudioCodes Mediant 800B MSBR User Manual page 881

Mediant 800B MSBR
Parameter
Web/EMS: Enable Caller ID
CLI: enable-caller-id
[EnableCallerID]
Web: Caller ID Type
EMS: Caller id Types
CLI: caller-ID-type
[CallerIDType]
Version 6.8
CallerDisplayInfo 0 = Susan C.,0,1,1;
the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2;
Caller ID for Port 2 of Module 1)
For a detailed description of this table, see Configuring Caller
Display Information on page 480.
Notes:

The indexing of this table ini file parameter starts at 0.

This parameter is applicable only to FXS and FXO
interfaces.
Global parameter that enables Caller ID.

[0] Disable (default)

[1] Enable =

FXS: The calling number and display text (from IP) are
sent to the device's port.

FXO or CAS: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the SIP
INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring Caller
Display Information on page 480. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions on page 483.
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) / generation
(FXS) of MWI (when specified) signals:

[0] Standard Bellcore = (Default) Caller ID and MWI

[1] Standard ETSI = Caller ID and MWI

[2] Standard NTT

[4] Standard BT = Britain

[16] Standard DTMF Based ETSI

[17] Standard Denmark = Caller ID and MWI

[18] Standard India

[19] Standard Brazil
Notes:

This parameter is applicable only to FXS and FXO
interfaces.

Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes the
Caller ID is detected before the first ring signal. In such a
scenario, set the RingsBeforeCallerID parameter to 0.

Caller ID detection for Britain [4] is not supported on the
device's FXO ports. Only FXS ports can generate the Britain
[4] Caller ID.

To select the Bellcore Caller ID sub standard, use the
BellcoreCallerIDTypeOneSubStandard parameter. To select
the ETSI Caller ID substandard, use the
ETSICallerIDTypeOneSubStandard parameter.

To select the Bellcore MWI sub standard, use the
BellcoreVMWITypeOneStandard parameter. To select the
ETSI MWI sub standard, use the
881
67. Configuration Parameters Reference
Description
("Susan C." is sent as
("Mark M." is sent as
Mediant 800B MSBR