Answer And Disconnect Supervision Parameters - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
Parameter
CLI: configure voip > gw
manipulations
CauseMapIsdn2Sip
[CauseMapISDN2SIP]
Release Cause Mapping from SIP to ISDN Table
Web: Release Cause Mapping
Table
EMS: SIP to ISDN Cause
Mapping
CLI: configure voip > gw
manipulations
CauseMapSip2Isdn
[CauseMapSIP2ISDN]

67.10.8 Answer and Disconnect Supervision Parameters

The answer and disconnect supervision parameters are described in the table below.
Parameter
Web: Wait before PSTN Release-Ack
CLI: wait-befor-pstn-rel-ack
[TimeToWaitForPstnReleaseAck]
Web: Answer Supervision
EMS: Enable Voice Detection
CLI: answer-supervision
[EnableVoiceDetection]
Web/EMS: Max Call Duration (min)
Version 6.8
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
This table parameter maps SIP responses to Q.850 Release
Causes. The format of the ini file table parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
Table 67-63: Answer and Disconnect Parameters
Defines a timeout (in milliseconds) that the device waits for
the receipt of an ISDN Q.931 Release message from the
PSTN side before releasing the channel. The Release ACK
is typically sent by the PSTN in response to the device's
Disconnect message to end the call. If the timeout expires
and a Release message has not yet been received, the
device releases the call channel.
The valid value is 1 to 360,000. The default is 6,000.
Note: This parameter is applicable only to Digital
interfaces.
Enables the sending of SIP 200 OK upon detection of
speech, fax, or modem.

[1] Yes = The device sends a SIP 200 OK (in response
to an INVITE message) when speech, fax, or modem is
detected (from the Tel side, for analog interfaces).

[0] No = (Default) The device sends a SIP 200 OK only
after it completes dialing (to the Tel side, for analog
interfaces).
Typically, this feature is used only when early media
(enabled using the EnableEarlyMedia parameter) is used
to establish the voice path before the call is answered.
Notes:

FXO interfaces: This feature is applicable only to one-
stage dialing (FXO).

Digital interfaces: To activate this feature, set the
EnableDSPIPMDetectors parameter to 1.

Digital interfaces: This feature is applicable only when
the protocol type is CAS.
Defines the maximum duration (in minutes) of a call. If this
67. Configuration Parameters Reference
Description
Description
941 Mediant 800B MSBR