Isdn And Cas Interworking Parameters - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
Parameter
Web/EMS: D-channel Configuration
CLI: isdn-nfas-dchannel-type
[DChConfig_x]
Web: NFAS Interface ID
EMS: ISDN NFAS Interface ID
CLI: isdn-nfas-interface-id
[ISDNNFASInterfaceID_x]

67.10.7 ISDN and CAS Interworking Parameters

The ISDN and CAS interworking parameters are described in the table below.
Parameter
ISDN Parameters
Web: Send Local Time To
ISDN Connect
[SendLocalTimeToISDNConn
ect]
Version 6.8
number. With NFAS, you can use a single D-channel to
control multiple PRI interfaces.
Notes:

For this parameter to take effect, a device reset is
required.

This parameter is applicable only to T1 ISDN protocols.

The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.

For more information on NFAS, see ISDN Non-Facility
Associated Signaling (NFAS) on page 360.
Defines primary, backup (optional), and B-channels only, per
trunk.

[0] PRIMARY= (Default) Primary Trunk - contains a D-
channel that is used for signaling.

[1] BACKUP = Backup Trunk - contains a backup D-
channel that is used if the primary D-channel fails.

[2] NFAS = NFAS Trunk - contains only 24 B-channels,
without a signaling D-channel.
Notes:

This parameter is applicable only to T1 ISDN protocols.

The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Defines a different Interface ID per T1 trunk.
The valid range is 0 to 100. The default interface ID equals
the trunk's ID.
Notes:

To set the NFAS interface ID, configure ISDNIBehavior_x
to include '512' feature per T1 trunk.

The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.

For more information on NFAS, see ISDN Non-Facility
Associated Signaling (NFAS) on page 360.
Table 67-62: ISDN and CAS Interworking Parameters
Determines the device's handling of the date and time sent in the
ISDN Connect message (Date / Time IE) upon receipt of SIP 200
OK messages.

[0] Disable = (Default) If the SIP 200 OK includes the Date
header, the device sends its value in the ISDN Connect Date /
Time IE. If the 200 OK does not include this header, it does not
add the Date / Time IE to the sent ISDN Connect message.

[1] Enable = If the SIP 200 OK includes the Date header, the
67. Configuration Parameters Reference
Description
Description
925 Mediant 800B MSBR