AudioCodes Mediant 800B MSBR User Manual page 923

Multi-service business router; session border controller
Hide thumbs Also See for Mediant 800B MSBR:
Table of Contents

Advertisement

Mediant 800B MSBR
Parameter
[ISDNOutCallsBehavior_x]
Web: ISDN NS Behaviour 2
CLI: isdn-bits-ns-extension-behavior
[ISDNNSBehaviour2]
[PSTNExtendedParams]
BRI Parameters
BRI Layer 2 Mode
CLI: isdn-layer2-mode
[BriLayer2Mode]
CLI: tei-config-p2p (config-voice >
Version 6.8
67. Configuration Parameters Reference
support several ISDNOutCallsBehavior features, add the
individual feature values. For example, to support both [2]
and [16] features, set ISDNOutCallsBehavior = 18 (i.e., 2 +
16).
Same as the description for parameter
ISDNOutCallsBehavior, but for a specific trunk ID.
Bit-field to determine several behavior options that influence
the behavior of the Q.931 protocol.
[8] NS BEHAVIOUR2 ANY UUI = Any User to User
Information Element (UUIE) is accepted for any protocol
discriminator. This is useful for interoperability with non-
standard switches.
[16] NS BEHAVIOUR2 DISPLAY = The Display IE is
accepted even if it is not defined in the QSIG ISDN
protocol standard. This is applicable only when
configuration is QSI.
[64] NS BEHAVIOUR2 FAC REJECT = When this bit is
set, the device answers with a Facility IE message with
the Reject component on receipt of Facility IE with
unknown/invalid Invoke component. This bit is
implemented in QSIG and ETSI variants.
Determines the bit map for special PSTN behavior
parameters:
[0] = (Default) Applicable for NI-2 ISDN and QSIG
"Networking Extensions". This bit (i.e., bit #0) is
responsible for the Invoke ID size:
If this bit is not set (default), then the Invoke ID size
is always one byte, with a value of 01 to 7f.
If this bit is set, then the Invoke ID size is one or two
bytes according to the Invoke ID value.
[2] = Applicable to the ROSE format (according to the old
QSIG specifications). This bit (i.e., bit #1) is responsible
for the QSIG octet 3. According to the ECMA-165 new
version, octet 3 in all QSIG supplementary services
Facility messages should be 0x9F = Networking
Extensions. However, according to the old version, the
value should be 0x91 = ROSE:
If this bit is not set (default): 0x9F = Networking
Extensions.
If this bit is set: 0x91 = ROSE.
[3] = Use options [0] and [2] above.
Note: For this parameter to take effect, a device reset is
required.
Defines Point-to-Point (P2P) or Point-to-Multipoint (P2MP)
mode for BRI ports.
[0] Point to Point (default)
[1] Point to Multipoint = Must be configured for Network
side.
Defines the BRI terminal endpoint identifier (TEI) when in
923
Description
Mediant 800B MSBR

Advertisement

Table of Contents
loading

Table of Contents