Web Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]

67.1.2 Web Parameters

The Web parameters are described in the table below.
Parameter
Web: Password Change Interval
[WebUserPassChangeInterval]
Web: User Inactivity Timer
[UserInactivityTimer]
Web: Session Timeout
[WebSessionTimeout]
Web: Deny Access On Fail Count
[DenyAccessOnFailCount]
User's Manual
This table configures up to ten IP addresses that are permitted to
access the device's Web interface and Telnet interfaces. Access from
an undefined IP address is denied. When no IP addresses are defined
in this table, this security feature is inactive (i.e., the device can be
accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of this parameter, see ''Configuring Web and Telnet
Access List'' on page 73.
Table 67-2: Web Parameters
Defines the duration (in minutes) of the validity of Web
login passwords. When this duration expires, the
password of the Web user must be changed.
The valid value is 0 to 100000, where 0 means that the
password is always valid. The default is 1140.
Note: This parameter is applicable only when using the
Web Users table, where the default value of the
'Password Age' parameter in the Web Users table
inherits this parameter's value.
Defines the duration (in days) for which a user has not
logged in to the Web interface, after which the status of
the user becomes inactive and can no longer access the
Web interface. These users can only log in to the Web
interface if their status is changed (to New or Valid) by a
System Administrator or Master user.
The valid value is 0 to 10000, where 0 means inactive.
The default is 90.
Note: This parameter is applicable only when using the
Web Users table.
Defines the duration (in minutes) of Web inactivity of a
logged-in user, after which the user is automatically
logged off the Web interface.
The valid value is 0-100000, where 0 means no timeout.
The default is 15.
Note: This parameter can apply to all users, or per user
when set in the Web Users table.
Defines the maximum number of failed login attempts,
after which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1
mean immediate block. The default is 3.
764
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813