AudioCodes Mediant 800B MSBR User Manual page 911

Mediant 800B MSBR
Parameter
Web/EMS: Line Code
CLI: line-code
[LineCode]
[LineCode_x]
[AdminState]
[TrunkAdministrativeState_x]
Web/EMS: Line Build Out Loss
CLI: line-build-out-loss
[LineBuildOut.Loss]
[TDMHairPinning]
Web: Enable TDM Tunneling
EMS: TDM Over IP
CLI: tdm-tunneling
[EnableTDMoverIP]
Version 6.8
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1 spans.

[0] B8ZS = (Default) B8ZS line code (for T1 trunks only).

[1] AMI = AMI line code.

[2] HDB3 = HDB3 line code (for E1 trunks only).
Note: This parameter is not configurable for BRI interfaces; the
device automatically uses the Modified Alternate Mark Invert
(MAMI) line code.
Same as the description for parameter LineCode, but for a specific
trunk ID (where 0 denotes the first trunk).
Defines the administrative state for all trunks.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = Shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Notes:

For this parameter to take effect, a device reset is required.

When the device is locked from the Web interface, this
parameter changes to 0.

To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
Defines the administrative state per trunk, where x denotes the
trunk number.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Defines the line build out loss for the selected T1 trunk.

[0] 0 dB (default)

[1] -7.5 dB

[2] -15 dB

[3] -22.5 dB
Note: This parameter is applicable only to T1 trunks.
Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-channel in each trunk. Format example: T0-
T1/B3,T2-T3,T4-T5/B2.
Note: For this parameter to take effect, a device reset is required.
Enables TDM tunneling.

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is required.

TDM Tunneling is applicable only to E1/T1 interfaces (not BRI).

For an overview on TDM tunneling, see TDM Tunneling on page
355.
911
67. Configuration Parameters Reference
Description
Mediant 800B MSBR