Resource Allocation Indication Parameters - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
Parameter
Debug Recording Status
CLI: configure system >
logging > dbg-rec-status
[DebugRecordingStatus]
Web: Enable Core Dump
[EnableCoreDump]
Web: Core Dump Destination
IP
[CoreDumpDestIP]
Logging Filters Table
Web: Logging Filters Table
CLI: configure system >
logging > logging-filters
[LoggingFilters]

67.3.4 Resource Allocation Indication Parameters

The Resource Allocation Indication (RAI) parameters are described in the table below.
Parameter
[EnableRAI]
[RAIHighThreshold]
Version 6.8
Activates or de-activates debug recording.

[0] Stop (default)

[1] Start
Enables the automatic generation of a Core Dump file upon a device
crash.

[0] Disable (disable)

[1] Enable
Defines the IP address of the remote server where you want the
device to send the Core Dump file.
By default, no IP address is defined.
This table parameter defines logging filtering rules for Syslog
messages and debug recordings.
The format of the ini file table parameter is:
[ LoggingFilters ]
FORMAT LoggingFilters_Index = LoggingFilters_FilterType,
LoggingFilters_Value, LoggingFilters_Syslog,
LoggingFilters_CaptureType;
[ \LoggingFilters ]
For a detailed description of this table, see ''Filtering Syslog
Messages and Debug Recordings'' on page 722.
Table 67-23: RAI Parameters
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.

[0] = (Default) Disable

[1] = Enable
Note: For this parameter to take effect, a device reset is required.
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of "enabled" endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
793
67. Configuration Parameters Reference
Description
Description
Mediant 800B MSBR