AudioCodes Mediant 800B MSBR User Manual page 766

Parameter
[ResetWebPassword]
[WelcomeMessage]
User's Manual
Description
Resets the username and password of the primary
("Admin") and secondary ("User") accounts to their
default settings ("Admin" and "Admin" respectively), and
deletes all other users that may have been configured.

[0] = (Default) Password and username retain their
values.

[1] = Password and username are reset.
Notes:

For this parameter to take effect, a device reset is
required.

You cannot reset the username and password
through the Web interface (by loading an ini file or on
the AdminPage). To reset the username and
password:

SNMP:
1) Set acSysGenericINILine to
WEBPasswordControlViaSNMP = 1, and reset
the device with a flash burn (set
acSysActionSetResetControl to 1 and
acSysActionSetReset to 1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following
format:
Username acSysWEBAccessUserName:
old/pass/new
Password acSysWEBAccessUserCode:
username/old/new
Enables and defines a Welcome message that appears
on the Web Login page for logging in to the Web
interface.
The format of this parameter is as follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index =
WelcomeMessage_Text
[\WelcomeMessage]
For Example:
FORMAT WelcomeMessage_Index =
WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome
message ***" ;
WelcomeMessage 3 = "**********************************" ;
Notes:

Each index row represents a line of text in the
Welcome message box. Up to 20 lines (or rows) of
text can be defined.

The configured text message must be enclosed in
double quotation marks (i.e., "...").

If this parameter is not configured, no Welcome
message is displayed.
766
Mediant 800B MSBR
Document #: LTRT-12813