AudioCodes Mediant 800B MSBR User Manual page 860

Parameter
Web: Disable RTCP XR Interval
Randomization
EMS: Disable Interval
Randomization
CLI: disable-RTCP-randomization
[DisableRTCPRandomize]
EMS: RTCP XR Collection Server
Transport Type
[RTCPXRESCTransportType]
Web: RTCP XR Collection Server
EMS: Esc IP
CLI: rtcp-xr-coll-srvr
[RTCPXREscIP]
Web: Gateway RTCP XR Report
Mode
EMS: Report Mode
CLI: rtcp-xr-rep-mode
[RTCPXRReportMode]
Web: SBC RTCP XR Report Mode
CLI: sbc-rtcpxr-report-mode
[SBCRtcpXrReportMode]
User's Manual
shorter than this interval, RTCP XR is sent only at the end of
the call.
The valid value range is 0 to 65,535. The default is 5,000.
Determines whether RTCP report intervals are randomized or
whether each report interval accords exactly to the parameter
RTCPInterval.

[0] Disable = (Default) Randomize

[1] Enable = No Randomize
Defines the transport layer used for outgoing SIP dialogs
initiated by the device to the RTCP XR Collection Server.

[-1] Not Configured (default)

[0] UDP

[1] TCP

[2] TLS
Notes:

When set to [-1], the value of the SIPTransportType
parameter is used.

This parameter is applicable only to the Gateway
application.
Defines the IP address of the Event State Compositor (ESC).
The device sends RTCP XR reports to this server, using SIP
PUBLISH messages, according to Internet-Draft draft-ietf-
sipping-rtcp-summary-13. The address can be configured as a
numerical IP address or as a domain name.
Note: This parameter is applicable only to the Gateway
application.
Determines whether RTCP XR reports are sent to the Event
State Compositor (ESC) and defines the interval at which they
are sent.

[0] Disable = (Default) RTCP XR reports are not sent.

[1] End Call = RTCP XR reports are sent at the end of each
call.

[2] End Call & Periodic = RTCP XR reports are sent at the
end of each call and periodically according to the
RTCPInterval parameter.
Note: This parameter is applicable only to the Gateway
application.
Enables the sending of RTCP XR reports of QoE metrics at
the end of each call session (i.e., after a SIP BYE). The RTCP
XR is sent in the SIP PUBLISH message.

[0] Disable (default)

[1] End of Call
Note: This parameter is applicable only to the SBC
application.
860
Mediant 800B MSBR
Description
Document #: LTRT-12813