Tdm Bus And Clock Timing Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
CLI: iso8859-charset
[ISO8859CharacterSet]
67.10.6.2 T DM Bus and Clock Timing Parameters
6 6 6 B
The TDM Bus parameters are described in the table below.
Table 67-59: TDM Bus and Clock Timing Parameters
Parameter
TDM Bus Parameters
Web/EMS: PCM Law Select
[PCMLawSelect]
Web/EMS: Idle PCM Pattern
CLI: idle-pcm-pattern
[IdlePCMPattern]
Web/EMS: Idle ABCD Pattern
[IdleABCDPattern]
User's Manual
Defines the ISO 8859 character set type (languages) for
representing the alphanumeric string of the calling name (caller ID)
in the forwarded message, for IP-to-Tel and Tel-to-IP calls.

[0] No Accented = Proprietary method where incoming INVITE
messages with any accented characters (e.g., ‫ ,ב, י, ם, ף‬and ),
which are represented in a 2-byte unicode character, are
translated to Latin-only, which are normal one-byte ASCII
characters (a, e, i, o, and u, respectively).

[1] Western European (Default)

[2] Central European

[3] South European

[4] North European

[5] Cyrillic

[6] Arabic

[7] Hebrew

[8] Turkish
Determines the type of pulse-code modulation (PCM) companding
algorithm law in input and output TDM bus.

[1] Alaw

[3] MuLaw
The default value is automatically selected according to the
Protocol Type of the selected trunk: E1 defaults to ALaw, T1
defaults to MuLaw. If the Protocol Type is set to NONE, the default
is MuLaw.
Notes:

For this parameter to take effect, a device reset is required.

Typically, A-Law is used for E1 spans and Mu-Law for T1/J1
spans.
Defines the PCM Pattern that is applied to the E1/T1 timeslot (B-
channel) when the channel is idle.
The range is 0 to 255. The default is set internally according to the
Law select 1 (0xFF for Mu-Law; 0x55 for A-law).
Note: For this parameter to take effect, a device reset is required.
Defines the ABCD (CAS) Pattern that is applied to the CAS
signaling bus when the channel is idle.
The valid range is 0x0 to 0xF. The default is -1 (i.e., default pattern
is 0000).
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only when using PSTN interface
912
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813