Sip Test Call Parameters - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
Parameter
Web: Delay After Reset [sec]
CLI: delay-after-reset
[GWAppDelayTime]
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
Web: Ignore BRI LOS Alarm
CLI: ignore-bri-los-alarm
[IgnoreBRILOSAlarm]

67.3.2 SIP Test Call Parameters

The SIP Signaling Test Call parameters are described in the table below.
Parameter
Web: Test Call DTMF
String
CLI:testcall-dtmf-string
[TestCallDtmfString]
Web: Test Call ID
CLI: testcall-id
[TestCallID]
Version 6.8
Manual.
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)

[1] Enable
Enables the device to ignore LOS alarms received from the BRI
user-side trunk and attempts to make a call (relevant for IP-to-Tel
calls).

[0] Disable

[1] Enable (default)
Note: This parameter is applicable only to BRI interfaces.
Table 67-21: SIP Test Call Parameters
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is
defined.
Notes:

This parameter is only for testing incoming calls destined to this
prefix number.

This feature is applicable to all applications (Gateway and SBC).
787
67. Configuration Parameters Reference
Description
Description
Mediant 800B MSBR