Configuring Caller Id Permissions - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
31.8

Configuring Caller ID Permissions

The Caller ID Permissions table lets you enable per port, Caller ID generation for FXS
interfaces and Caller ID detection for FXO interfaces.
Note:
generation / detection is determined according to the global parameter, 'Enable Call
ID' in the Supplementary Services page (Configuration tab > VoIP menu > GW and
IP to IP > DTMF and Supplementary > Supplementary Services).
The following procedure describes how to configure caller ID permissions in the Web
interface. You can also configure this using the table ini file parameter, EnableCallerID or
the CLI command, configure voip > gw analoggw enable-caller-id.

To configure caller ID permissions per port:
1. Open the Caller ID Permissions page (Configuration tab > VoIP menu > GW and IP
to IP > Analog Gateway > Caller ID Permissions).
2. Click Add; the following dialog box appears:
3. Configure a caller ID permission per port according to the parameters described in the
table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 31-5: Caller ID Permissions Table Parameter Descriptions
Parameter
Index
[EnableCallerId_Index]
Module
[EnableCallerId_Module]
Port
[EnableCallerId_Port]
Port Type
[EnableCallerId_PortType]
Caller ID
CLI: caller-id
[EnableCallerId_IsEnabled]
Version 6.8
If Caller ID permissions is not configured for a port in this table, its Caller ID
Figure 31-6: Caller ID Permissions Page - Edit Record
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
(Read-only) Displays the module number on which the port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (e.g., FXS).
Enables Caller ID generation (FXS) or detection (FXO) per port.

[0] Disable

[1] Enable
Description
483
31. Analog Gateway
Mediant 800B MSBR