AudioCodes Mediant 800B MSBR User Manual page 960

Parameter
EMS: Country Coefficients
CLI: fxs-country-coefficients
[FXSCountryCoefficients]
FXO Parameters
Web: FXO Coefficient Type
EMS: Country Coefficients
CLI: fxo-country-coefficients
[CountryCoefficients]
CLI: fxo-dc-termination
[FXODCTermination]
CLI: enable-fxo-current-limit
[EnableFXOCurrentLimit]
[FXONumberOfRings]
Web/EMS: Dialing Mode
CLI: dialing-mode
[IsTwoStageDial]
Web/EMS: Waiting For Dial
Tone
CLI: waiting-4-dial-tone
User's Manual
USA or Europe (TBR21) standards.

[66] Europe = TBR21

[70] USA = (Default) United States
Note: For this parameter to take effect, a device reset is required.
Determines the FXO line characteristics (AC and DC) according to
USA or TBR21 standard.

[66] Europe = TBR21

[70] USA = (Default) United States
Note: For this parameter to take effect, a device reset is required.
Defines the FXO line DC termination (i.e., resistance).

[0] = (Default) DC termination is set to 50 Ohms.

[1] = DC termination set to 800 Ohms. The termination changes
from 50 to 800 Ohms only when moving from onhook to offhook.
Note: For this parameter to take effect, a device reset is required.
Enables limiting the FXO loop current to a maximum of 60 mA
(according to the TBR21 standard).

[0] = (Default) FXO line current limit is disabled.

[1] = FXO loop current is limited to a maximum of 60 mA.
Note: For this parameter to take effect, a device reset is required.
Defines the number of rings before the device's FXO interface
answers a call by seizing the line.
The valid range is 0 to 10. The default is 0.
When set to 0, the FXO seizes the line after one ring. When set to
1, the FXO seizes the line after two rings.
Notes:

This parameter is applicable only if automatic dialing is not
used.

If caller ID is enabled and if the number of rings defined by the
parameter RingsBeforeCallerID is greater than the number of
rings defined by this parameter, the greater value is used.
Determines the dialing mode for IP-to-Tel (FXO) calls.

[0] One Stage = One-stage dialing. In this mode, the device
seizes one of the available lines (according to the
ChannelSelectMode parameter), and then dials the destination
phone number received in the INVITE message. To specify
whether the dialing must start after detection of the dial tone or
immediately after seizing the line, use the IsWaitForDialTone
parameter.

[1] Two Stages = (Default) Two-stage dialing. In this mode, the
device seizes one of the PSTN/PBX lines without performing
any dialing, connects the remote IP user to the PSTN/PBX, and
all further signaling (dialing and Call Progress Tones) is
performed directly with the PBX without the device's
intervention.
Note: This parameter can be configured for a Tel Profile.
Determines whether or not the device waits for a dial tone before
dialing the phone number for IP-to-Tel (FXO) calls.
960
Mediant 800B MSBR
Description
Document #: LTRT-12813