Fxo Gateway Configuration - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR

31.14.6 FXO Gateway Configuration

The following procedure describes how to configure the FXO interface (to which the PBX is
directly connected).

To configure the FXO interface:
1. In the Trunk Group table (see Configuring Trunk Group Table on page 365), assign
the phone numbers 200 to 204 to the device's FXO endpoints.
2. In the Automatic Dialing page, enter the phone numbers of the FXS device in the
'Destination Phone Number' fields. When a ringing signal is detected at Port #1, the
FXO device automatically dials the number '100'.
3. In the Outbound IP Routing table, enter 10 in the 'Destination Phone Prefix' field, and
the IP address of the FXS device (10.1.10.3) in the field 'IP Address'.
4. In the FXO Settings page (see ''Configuring FXO Parameters'' on page 476), set the
parameter 'Dialing Mode' to Two Stages (IsTwoStageDial = 1).
Version 6.8
Figure 31-14: Assigning Phone Numbers to FXO Ports
Figure 31-15: FXO Automatic Dialing Configuration
Figure 31-16: FXO Tel-to-IP Routing Configuration
497
31. Analog Gateway
Mediant 800B MSBR