Configuring Sbc Ip-To-Ip Routing - AudioCodes Mediant 800B MSBR User Manual


To configure a Message Condition rule:
1. Open the Message Condition Table page (Configuration tab > VoIP menu > SBC >
Routing SBC > Message Condition Table).
2. Click Add; the following dialog box appears:
Figure 37-3: Condition Table Page - Add Record Dialog Box
3. Configure a Message Condition rule according to the parameters described in the
table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
An example of configured Message Condition rules is shown in the figure below:

Index 0: Incoming SIP dialog that is classified as belonging to a User-type IP Group.

Index 1: Incoming SIP dialog that contains a SIP Via header.

Index 2: Incoming SIP dialog with 101 as the user part in the SIP From header.
Table 37-2: Message Condition Table Parameter Descriptions
Parameter
Index
[ConditionTable_Index]
Condition
CLI: condition
[ConditionTable_Condition]
Description
CLI: description
[ConditionTable_Description]
37.3

Configuring SBC IP-to-IP Routing

The IP-to-IP Routing table lets you configure up to 500 SBC IP-to-IP routing rules. An IP-
to-IP routing rule routes received SIP dialog messages (e.g., INVITE) to an IP destination.
An IP-to-IP routing rule includes two areas:

Matching characteristics (Rule) - characteristics of incoming SIP message such as the
IP Group from where the message was received.

Operation (Action) - if the incoming SIP message matches the characteristics of the
rule, the device routes the message to the configured destination
User's Manual
Figure 37-4: Condition Table Page
Defines an index number for the new table record.
Defines the Condition rule of the SIP message.
The valid value is a string.
Note: User and host parts must be enclosed in single quotes.
Defines a brief description of the Condition rule.
552
Mediant 800B MSBR
Description
Document #: LTRT-12813