Call Cut-Through Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
CLI: dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP]
Web/EMS: RTP DSCP for MLPP
Immediate
CLI: dscp-4-mlpp-immed
[MLPPImmediateRTPDSCP]
Web/EMS: RTP DSCP for MLPP
Flash
CLI: dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Web/EMS: RTP DSCP for MLPP
Flash Override
CLI: dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDSCP]
Web/EMS: RTP DSCP for MLPP
Flash-Override-Override
CLI: dscp-4-mlpp-flsh-ov-ov
[MLPPFlashOverOverRTPDSCP]
67.10.5.10

Call Cut-Through Parameters

The call cut-through parameters are described in the table below.
Parameter
Web: Enable Calls Cut
Through
EMS: Cut Through
CLI: calls-cut-through
[CutThrough]
User's Manual
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Defines the RTP DSCP for MLPP Immediate precedence call
level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Defines the RTP DSCP for MLPP Flash precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Defines the RTP DSCP for MLPP Flash-Override precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Defines the RTP DSCP for MLPP Flash-Override-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Table 67-54: Call Cut-Through Parameters
Enables FXS endpoints to receive incoming IP calls while the port is in off-
hook state.

[0] Disable (default)

[1] Enable
If enabled, the FXS interface answers the call and 'cuts through' the voice
channel if there is no other active call on the port, even if the port is in off-
hook state.
When the call is terminated (by the remote IP party), the device plays a
reorder tone for a user-defined time (configured by the
CutThroughTimeForReorderTone parameter) and is then ready to answer
the next incoming call without on-hooking the phone.
The waiting call is automatically answered by the device when the current
call is terminated (configured by setting the parameter EnableCallWaiting
to 1).
902
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813