AudioCodes Mediant 800B MSBR User Manual page 916

Parameter
[CASTablesNum]
CAS State Machines Parameters
Note: For configuring the CAS State Machine table using the Web interface, see ''Configuring CAS
State Machines'' on page 352. The CAS state machine can be configured only through the Web-
based management tool.
Web: Generate Digit On Time
[CASStateMachineGenerateDig
itOnTime]
Web: Generate Inter Digit Time
[CASStateMachineGenerateInte
rDigitTime]
Web: DTMF Max Detection Time
[CASStateMachineDTMFMaxOn
DetectionTime]
Web: DTMF Min Detection Time
[CASStateMachineDTMFMinOn
DetectionTime]
Web: MAX Incoming Address
Digits
[CASStateMachineMaxNumOfI
ncomingAddressDigits]
Web: MAX Incoming ANI Digits
[CASStateMachineMaxNumOfI
ncomingANIDigits]
Web: Collect ANI
[CASStateMachineCollectANI]
User's Manual
variants:
ProtocolType_5 = 8
CASFILENAME_2='E1_R2D'
CASFILENAME_7= E_M_ImmediateTable_A-Bit.txt'
CasChannelIndex_5 = '1-10:2,11-20:7,21-31:2'
Notes:

To configure this parameter, the trunk must first be stopped.

Only one of these formats can be implemented; not both.

When this parameter is not configured, a single CAS table for
the entire trunk is used, configured by the parameter
CASTableIndex.
Defines how many CAS protocol configurations files are loaded.
The valid range is 1 to 8.
Note: For this parameter to take effect, a device reset is required.
Generates digit on-time (in msec).
The value must be a positive value. The default is -1.
Generates digit off-time (in msec).
The value must be a positive value. The default is -1.
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1.
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may be
used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1.
Defines the limitation for the maximum address digits that need to
be collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default is -1.
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of
ANI digits is stopped.
The value must be an integer. The default is -1.
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can enable the state
machine to collect ANI or discard ANI.

[0] No = Don't collect ANI.

[1] Yes = Collect ANI.

[-1] Default = Default value.
916
Mediant 800B MSBR
Description
Document #: LTRT-12813