AudioCodes Mediant 800B MSBR User Manual page 852

Parameter
EMS: Payload Format
CLI: G726-voice-payload-format
[VoicePayloadFormat]
Web: MF Transport Type
CLI: MF-transport-type
[MFTransportType]
Web: Silence Suppression
EMS: Silence Compression Mode
CLI: silence-compression-mode
[EnableSilenceCompression]
Web: Echo Canceler
EMS: Echo Canceller Enable
CLI: echo-canceller-enable
[EnableEchoCanceller]
Web: Network Echo Suppressor Enable
CLI: acoustic-echo-suppressor-enable
[AcousticEchoSuppressorSupport]
Web: Echo Canceller Type
CLI: echo-canceller-type
[EchoCancellerType]
User's Manual
Description
Note: If this functionality is configured for a specific profile,
the settings of this global parameter is ignored for calls
associated with the profile.
Determines the bit ordering of the G.726/G.727 voice
payload format.

[0] = (Default) Little Endian

[1] = Big Endian
Note: To ensure high voice quality when using
G.726/G.727, both communicating ends should use the
same endianness format. Therefore, when the device
communicates with a third-party entity that uses the
G.726/G.727 voice coder and voice quality is poor, change
the settings of this parameter (between Big Endian and
Little Endian).
Currently, not supported.
Global parameter that enables the Silence Suppression
feature. You can also configure this functionality per
specific calls, using IP Profiles (IpProfile_SCE). For a
detailed description of this parameter and for configuring
this functionality in the IP Profile table, see ''Configuring IP
Profiles'' on page 314.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored for
calls associated with the IP Profile.
Global parameter that enables echo cancellation (i.e., echo
from voice calls is removed). You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_EnableEchoCanceller) or Tel Profiles. For a
detailed description of this parameter and for configuring
this functionality in the IP Profile table, see ''Configuring IP
Profiles'' on page 314 or Tel Profile table, see Configuring
Tel Profiles on page 311.
Note: If this functionality is configured for a specific profile,
the settings of this global parameter is ignored for calls
associated with the profile.
Enables the network Acoustic Echo Suppressor feature on
SBC calls. This feature removes echoes and sends only
the near-end's desired speech signal to the network (i.e., to
the far-end party).

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is
required.
Defines the echo canceller type.

[0] Line echo canceller = (Default) Echo canceller for
Tel side.

[1] Acoustic Echo suppressor - netw = Echo canceller
for IP side.
852
Mediant 800B MSBR
Document #: LTRT-12813