AudioCodes Mediant 800B MSBR User Manual page 895

Mediant 800B MSBR
Parameter
CLI: enable-3w-conf
[Enable3WayConference]
Web: 3-Way Conference Mode
EMS: 3 Way Mode
CLI: 3w-conf-mode
[3WayConferenceMode]
Web: Max. 3-Way Conference
EMS: Max In Board Calls
[MaxInBoardConferenceCalls]
Web: Establish Conference Code
EMS: Establish Code
CLI: estb-conf-code
Version 6.8

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
Defines the mode of operation for three-way conferencing.

[0] AudioCodes Media Server = (Default) The conference-
initiating INVITE sent by the device, uses the ConferenceID
concatenated with a unique identifier as the Request-URI.
This same Request-URI is set as the Refer-To header value in
the REFER messages that are sent to the two remote parties.
This conference mode is used when operating with
AudioCodes IPMedia conferencing server.

[1] Non-AudioCodes Media Server = The conference-initiating
INVITE sent by the device, uses only the ConferenceID as the
Request-URI. The Conference server sets the Contact header
of the 200 OK response to the actual unique identifier
(Conference URI) to be used by the participants. This
Conference URI is then included by the device in the Refer-To
header value in the REFER messages sent by the device to
the remote parties. The remote parties join the conference by
sending INVITE messages to the conference using this
conference URI.

[2] On Board = On-board, three-way conference. The
conference is established on the device without the need of an
external Conference server. You can limit the number of
simultaneous, on-board 3-way conference calls, by using the
MaxInBoardConferenceCalls parameter.

[3] Huawei Media Server = The conference is managed by an
external, third-party Conferencing server. The conference-
initiating INVITE sent by the device, uses only the
ConferenceID as the Request-URI. The Conferencing server
sets the Contact header of the 200 OK response to the actual
unique identifier (Conference URI) to be used by the
participants. The Conference URI is included in the URI of the
REFER with a Replaces header sent by the device to the
Conferencing server. The Conferencing server then sends an
INVITE with a Replaces header to the remote participants.
Notes:

This parameter is applicable only to FXS and BRI interfaces.

Three-way conferencing using an external conference server
is supported only by FXS interfaces.

When using an external Conferencing server, a conference
call with up to six participants can be established.
Defines the maximum number of simultaneous, on-board three-
way conference calls.
The valid range is 0 to 5. The default is 2.
Notes:

For enabling on-board, three-way conferencing, use the
3WayConferenceMode parameter.

This parameter is applicable only to FXS and BRI interfaces.
Defines the DTMF digit pattern, which upon detection generates
the conference call when three-way conferencing is enabled
895
67. Configuration Parameters Reference
Description
Mediant 800B MSBR