AudioCodes Mediant 800B MSBR User Manual page 920

Parameter
[ISDNIBehavior_x]
User's Manual
ETSI.

[65536] EXPLICIT PRES SCREENING = The calling
party number (octet 3a) is always present even when
presentation and screening are at their default.
Note: This option is applicable only to ETSI, NI-2, and
5ESS.

[131072] STATUS INCOMPATIBLE STATE = Clears the
call on receipt of Q.931 Status with incompatible state.
Otherwise, no action is taken (default).

[262144] STATUS ERROR CAUSE = Clear call on
receipt of Status according to cause value.

[524288] ACCEPT A LAW =A-Law is also accepted in
5ESS.

[2097152] RESTART INDICATION = Upon receipt of a
Restart message, acEV_PSTN_RESTART_CONFIRM is
generated.

[4194304] FORCED RESTART = On data link
(re)initialization, send RESTART if there is no call.

[67108864] NS ACCEPT ANY CAUSE = Accept any
Q.850 Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.

[134217728] NS_BRI_DL_ALWAYS_UP (0x08000000) =
By default, the BRI D-channel goes down if there are no
active calls. If this option is configured, the BRI D-channel
is always up and synchronized.

[536870912] = Alcatel coding for redirect number and
display name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant
for specific Alcatel PBXs such as OXE).

[1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding
(compliant to new ECMA standards); otherwise, OBJECT
IDENTIFIER ASN.1 type is used.
Note: This option is applicable only to QSIG.

[2147483648] 5ESS National Mode For Bch
Maintenance = Use the National mode of AT&T 5ESS for
B-channel maintenance.
Notes:

To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feature
values. For example, to support both [512] and [2048]
features, set the parameter ISDNIBehavior is set to 2560
(i.e., 512 + 2048).

When configuring in the Web interface, to select the
options click the arrow button and then for each required
option select 1 to enable.

For BRI terminal endpoint identifier (TEI) configuration,
instead of using the ISDNIBehavior parameter, use the
following parameters: BriTEIConfigP2P_x,
BriTEIConfigP2MP_x, BriTEIAssignTrigger_x, and
BriTEIRemoveTrigger_x.
Same as the description for parameter ISDNIBehavior, but
for a specific trunk ID.
920
Mediant 800B MSBR
Description
Document #: LTRT-12813