AudioCodes Mediant 800B MSBR User Manual page 475

Mediant 800B MSBR
Notes:
•
The Metering Tones page is available only for FXS interfaces.
•
Charge Code rules can be assigned to routing rules in the Outbound IP Routing
table (see ''Configuring Outbound IP Routing Table'' on page 397). When a new
call is established, the Outbound IP Routing table is searched for the destination
IP address. Once a route is located, the Charge Code (configured for that route) is
used to associate the route with an entry in the Charge Codes table.

To configure Metering tones:
1. Open the Metering Tones page (Configuration tab > VoIP menu > GW and IP to IP >
Analog Gateway > Metering Tones).
2. Configure the Metering tones parameters as required. For a description of the
parameters appearing on this page, see ''Configuration Parameters Reference'' on
page 763.
3. Click Submit.
4. To save the changes to the flash memory, see ''Saving Configuration'' on page 592.
If you set the 'Generate Metering Tones' parameter to Internal Table, access the Charge
Codes Table page by clicking the Charge Codes Table
on configuring the Charge Codes table, see ''Configuring Charge Codes'' on page 470.
Version 6.8
Figure 31-2: Metering Tones Page
475
31. Analog Gateway
button. For more information
Mediant 800B MSBR