AudioCodes Mediant 800B MSBR User Manual page 848

Parameter
Web: Number of RTX
Before Hot-Swap
EMS: Proxy Hot Swap Rtx
CLI: nb-of-rtx-b4-hot-swap
[HotSwapRtx]
SIP Message Manipulations Table
Web: Message
Manipulations
EMS: Message
Manipulations
CLI: configure voip > sbc
manipulations message-
manipulations
[MessageManipulations]
Message Policy Table
Web: Message Policy Table
CLI: configure voip > sbc
message-policy
[MessagePolicy]
User's Manual
Defines the number of retransmitted INVITE/REGISTER messages
before the call is routed (hot swap) to another Proxy/Registrar.
The valid range is 1 to 30. The default is 3.
Note: This parameter is also used for alternative routing. If a domain
name in the Outbound IP Routing table or SBC IP-to-IP Routing table
is resolved into two IP addresses, and if there is no response for
HotSwapRtx retransmissions to the INVITE message that is sent to the
first IP address, the device immediately initiates a call to the second IP
address.
This table parameter defines manipulation rules for SIP header
messages.
The format of the ini file table parameter is as follows:
[ MessageManipulations]
FORMAT MessageManipulations_Index =
MessageManipulations_ManSetID,
MessageManipulations_MessageType,
MessageManipulations_Condition,
MessageManipulations_ActionSubject,
MessageManipulations_ActionType,
MessageManipulations_ActionValue,
MessageManipulations_RowRole;
[\MessageManipulations]
For example, the below configuration changes the user part of the SIP
From header to 200:
MessageManipulations 1 = 0, Invite.Request, , Header.From.Url.User,
2, 200, 0;
For a detailed description of this table, see Configuring SIP Message
Manipulation on page 299.
This table parameter configures SIP message policy rules for blocking
(blacklist) unwanted incoming SIP messages or allowing (whitelist)
receipt of desired messages.
The format of the ini file table parameter is as follows:
[MessagePolicy]
FORMAT MessagePolicy_Index = MessagePolicy_Policy,
MessagePolicy_MaxMessageLength,
MessagePolicy_MaxHeaderLength, MessagePoliy_MaxBodyLength,
MessagePolicy_MaxNumHeaders, MessagePolicy_MaxNumBodies,
MessagePolicy_SendRejection, MessagePolicy_MethodListType,
MessagePolicy_MethodList, MessagePolicy_BodyListType,
MessagePolicy_BodyList;
[/MessagePolicy]
For a detailed description of this table, see Configuring SIP Message
Policy Rules.
848
Mediant 800B MSBR
Description
Document #: LTRT-12813