Isdn Bri Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
CLI: wink-time
[WinkTime]
67.10.5.13

ISDN BRI Parameters

The automatic dialing upon off-hook parameters are described in the table below.
Parameter
BRI-to-SIP Supplementary Services Codes for Call Forward
Note: Upon receipt of an ISDN Facility message for call forward from the BRI phone, the device
sends a SIP INVITE to the softswitch with a user-defined code in the SIP To header, representing the
reason for the call forward. For more information on BRI call forwarding, see ''BRI Call Forwarding'' on
page 434.
Web/EMS: Call Forward
Unconditional
[SuppServCodeCFU]
Web/EMS: Call Forward
Unconditional Deactivation
[SuppServCodeCFUDeact]
Web: Call Forward on Busy
EMS: Code Call Forward on
Busy
[SuppServCodeCFB]
User's Manual
signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable, EnableDID_Port,
EnableDID_Module;
[\EnableDID]
Where,

IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem
DID support.

Port = Port number.

Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: This parameter is applicable only to FXS interfaces.
Defines the time (in msec) elapsed between two consecutive polarity
reversals. This parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Notes:

This parameter is applicable to FXS and FXO interfaces.

For this parameter to take effect, a device reset is required.
Table 67-57: Automatic Dialing Parameters
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
Defines the prefix code for activating Call Forward on Busy sent to
the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
906
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813